Old Leaking Condenser Coils

Old Leaking Condenser Coils

Old coil with HVAC Refrigerant Leaks

Old Leaking Condenser Coils (also referred to as freon leaks) can cause serious issues with HVAC heat pump equipment. HVAC refrigeration circuits are designed and built to hold the refrigerant. It is a sealed hermetic system. The HVAC refrigeration circuit should never need refrigerant. An HVAC refrigeration system does not burn refrigerant. The refrigerant is used over and over again to move heat from one place to another. Aside from a leak, once the refrigeration system is properly charged, the system should never need refrigerant for the life of the equipment. (more…)

Air Conditioner Ductwork Leaks | Leaky Duct Work

Air Conditioner Ductwork Leaks | Leaky Duct Work - A good consideration when replacing the air conditioning system is the ductwork.

Air Conditioner Ductwork Leaks

Red Arrow Shows a Duct Work Leak

Ductwork seems to be the most ignored part of an HVAC system. However, it is a very important consideration in this age of new technology and higher energy-efficient equipment being developed and manufactured. You can have the most energy-efficient engine but if it’s in an old 60 or 70’s model car your efficiency is going to suffer. The same is true with HVAC systems. (more…)

Air Conditioner Condensation Problems – Condensate Drain Plugged

air conditioning water damageAir Conditioner Condensation Problems - It is important for air conditioning preventive maintenance to be performed on your system to avoid problems. Condensation water leaking near the air handling unit can be avoided with proper air conditioning repair and preventive maintenance. Normally this is a very simple problem that can be fixed in less than 30 minutes. Here is a list of what can cause water around the outside of the air conditioning air handler unit.
(more…)

Duct Systems and Bad Ductwork

Duct Systems and Bad DuctworkBad Ductwork - Ductwork is necessary to deliver the air throughout the HVAC system. It is important that the system has integrity with no leaks. Ductwork is made of different materials. Duct systems also have different construction methods which hold the ductwork together.

Pictured above is an old ductwork system (which needs to be replaced) made of duct board, which is a rigid fiberglass board, metal, and flex ductwork. The duct board is cut to size from the ductwork sizing requirements for the tonnage and taped together with special duct tape. For the branches coming off the duct board trunk, metal collars are inserted into holes cut to size in the duct board. Flex ductwork is attached to the metal collars for the branch ductwork. (more…)