How to Wire a Run Capacitor to a Motor | Blowers & Condensers

by | Technical Reference | 2 comments

How to Wire a Run Capacitor to a Motor Blower & Condenser HVAC WiringHow to Wire a Run Capacitor to a Motor | Blowers & Condensers – Sometimes, when a blower or condenser fan motor goes bad, a technician or even a DIYer has issues wiring the new motor and capacitor. Most motors come with clear instructions or a wiring diagram on the side. However, some people still struggle with the wiring part of the motor to the capacitor.

Furthermore, it is important to get it right to prevent problems including burning up the new motor or even causing a dead short in the wiring and melting the wire. Additionally, a PSC motor will run without a capacitor. However, it will run at higher temperatures pulling more amperage than design. Here we will illustrate the proper wiring for a motor to a run capacitor. (more…)

Start Capacitors for HVAC Compressors | Motor Start Assist

by | Technical Reference | 6 comments

Start Capacitors for HVAC Compressors - Start Capacitor with Potential Relay
Start Capacitors for HVAC Compressors - HVAC single-phase compressors always come hooked up to a run capacitor. This helps the compressor when it is running, however, very few HVAC compressors come with a start capacitor. Most HVAC technicians know HVAC compressors pull a lot of amps on startup. This large amperage draws on startup is referred to technically as locked rotor amps or inrush current. It can be as much as 40,000 watts or more of pure power to get an HVAC compressor started. (more…)